If you are looking for a place where you can learn how to connect tube fittings then you are in the right place. Otherwise known as compression fittings accurately and securely everytime you make sure it’s safe for you and your workers. Before you install a tube fitting make sure you have done a proper research or you can expert advice of a TUBE FITTINGS SUPPLIERS IN JORDAN.
We Offer Revolution Of Industrial Engineering
Tube Fittings Suppliers in Jordan
Understanding Tube Fittings: A Guide to Proper Installation Techniques
Prepping Tubing
Make sure the tube is properly installed, it’s clean, its deburred so we want to make sure for a checklist of things to look for when performing a complete maintenance. Also make sure the tubbing harness matches the tube fitting specifications always check with your Tube Fittings Suppliers and that your tubing is certified to work with.
Installation Misconceptions
The tube fitting that you happen to be using, there is one big myth that is common in the industry and that’s when the tub fitting is tightened that a two fitting can be tightened and it’s a matter of torque. The reality is a tube fitting nut is tightened on the stainless steel tubing by the depth of that the nut is tightened to or number of turns from hand tight.
Tube Fitting Installation Procedure So how do you tighten a tube fitting properly?
So firstly you make sure you have a leak free safe connection every time there are standard guidelines for installing virtually. Every TUBE FITTINGS SUPPLIERS on the market or whatever brand you use a , a piece of tubing is inserted into a tube fitting until it bottoms out. There’s a shoulder in the back of it that we are going to bottom this tube fitting. It’s very important that we are going to hand tighten the nut until we can’t hand tighten anymore. At this point you can take a marker and mark the nut at the six o clock position along with the body. Continue to rotate this nut with a wrench one and one quarter turns from hand tight and bring it to the nine o clock position.
Installing a tube fitting is quite straightforward, but there's an important step to remember. We need to check whether Tube Fittings Suppliers in Jordan or any other manufacturer specifies in their instructions that after installing a tube fitting, we should use a gap gauge to measure the space between the nut and the body.
Improper Installation Hazards
Make sure the connection under tightening causes the ferrules inside not to bite which can at pressure release tubing making it become a projectile. Over tightening can damage and crush the ferrules, the nut and cause leakage. So we want to make sure that the nut is tightened to the precise spot every time.
